Jump to content

24/7 Bored Plug - Trial Run - Homemade


Fyrezice
 Share

Recommended Posts

After reading the post at [url="http://www.rosebuttboard.com/index.php?showtopic=32198"]http://www.rosebuttboard.com/index.php?showtopic=32198[/url] I ordered the Meo XL Plug. I must say that the service was excellent, but the plug was not the right shape for me and I could not keep it in place. My interest had been peaked however so over the last couple months I have been developing a made to measure version of a 24/7 plug.

I am using a 2" inside diameter plastic pipe, outside diameter 2-3/8". Since one has to be able to sit fairly comfortably on a 24/7 plug the first thing I did was to insert a 4 inch length of the pipe with the bottom end wrapped in a sponge soaked in Plaster of Paris and then sit on it until the Plaster of Paris cured. This experiment suggested that the bottom plug needs to be cut higher on the front and back to form a saddle shape. In further tests I discovered that the back side needs to be cut back about 3/4" and the front about 3/8". The longest part of the saddle shape is slightly forward of the center. I used silicone sealant to form a base on the outside that follows the saddle shape and is about 3/8" wider than the tube.

I next experimented with length and cut the tube off so that it was just past the rectal sphincter when it was laced in place.

Yesterday morning I started a trial run. The plug is comfortable when standing and there is no overwhelming urge to push it out. The plug enters a little deeper when I sit on it but it is not really uncomfortable. For the first few hours I was very aware of the plug but gradually it became to feel more natural. The tube must be constricting my urethra a bit because urine flow is not as free as normal. There were hints of cramping overnight but these passed and at almost 24 hours I am continuing the experiment.
Link to comment
Share on other sites

Not long after I posted the above the stopper suddenly failed. It took me over an hour to clean up the mess and rinse my clothes. Fortunately I had been aware that the stopper was likely to be unreliable and had a replacement prepared. I have been able to continue the experiment without removing the butt plug itself. The new stopper was manufactured specifically to cap off the type of pipe I am using. It tightens a rubber gasket between two plastic washers as a wing-nut is turned. I modified it so that the whole of it would fit totally inside the pipe rather than sitting on the end of the pipe. I have it tightened securely in place now and expect that it will prevent further accidents of this type.
Link to comment
Share on other sites

Thanks all for your interest.

I do not yet know how to post pictures on this site, but I will keep trying to figure it out.

To answer your question Thotun, the accidental spill was very fluid and it was the first movement since I started the trial.
Link to comment
Share on other sites

I was able to post a picture on another place on this site. After the trial period is over I will post pictures of the whole butt plug if you are interested.

The picture is posted [url="http://www.rosebuttboard.com/index.php?showtopic=50353&st=0&gopid=317012&#entry317012"]here[/url]. Edited by Fyrezice
Link to comment
Share on other sites

That first trial run was last weekend and it lasted a bit less than 48 hours. I was shooting for the 48 which was the time I had available before going back to work, but when I woke up about 3:30 AM Monday morning I decided I preferred to get a few hours more sleep rather than continued anal stimulation.

On the hole [sic] however, the experience was very positive and I am very happy with this prototype. One of the things I wondered about was what would happen with intestinal gas. As it turned out I began farting like a trooper after about the first 24 hours. The gas was escaping between the plug and my anus and just like with normal farts there was no leakage of feces.

I will post some pictures of the device in the future, but that will have to wait for a while because I am giving it another trial run as I write this.
Link to comment
Share on other sites

I posted a picture of the device out in the open and provide a bit of a description [url="http://www.rosebuttboard.com/index.php?showtopic=50353&st=0&gopid=321513&#entry321513"]here[/url].
Link to comment
Share on other sites

I posted a picture [url="http://www.rosebuttboard.com/index.php?showtopic=50353&st=0&gopid=325300&#entry325300"]here[/url], showing an inside view with a description of my adventures in getting the plug to come out.
Link to comment
Share on other sites

  • 4 weeks later...
  • 1 year later...
Join my group on x tube and share your experiences :)

http://www.xtube.com/groups/group_home.php?g=buttplug
Link to comment
Share on other sites

 Share

×
×
  • Create New...

Important Information

Terms of Use Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.